CandCCentral UK - PC Water Cooling, Computer Cooling, And Case Modding

The new generation has arrived radiator, the G-Changer of the manufacturing consortium Phobya!

Innovation and cooling are the two arguments, the choice to emphasize this radiator. No more? However, much more if we look at ourselves this radiator look!

The material is the foundation of every good radiator. Copper fins, the pre-chamber of brass are the traditional materials from which dreams are made of water users. The entire radiator was covered with black paint, and was applied to the plate just enough that the lens looks good, but the cooling performance is not affected. Phobya The company logo was embedded in the page and shows that the radiator, it must have in you!

After the foundation laid of the material and the apparent, we look back even more precisely what the Phobyaingenieure have considered: a better cooling performance is the be all and created at a new radiator. An improved flow leads to more cooling power, this is achieved by double channels, which increases the cross section of the line. In addition, the channels were equipped with additional internal channels, which increases the surface area and thus more heat from the cool wet can be removed. The fin spacing was chosen so that is slow to medium air flow rates the optimum ratio of fan noise and cooling performance. Of course, the cooling capacity is further increased in the 60mm thick radiator when extreemflow fan starts.

After the cooling follows the assembly. Again, there are innovations which it previously so did not exist! The 1 / 4 "port openings shall be provided at the front or the bottom as in-or outlet available. This increased the possibility of mounting the radiator. Two of the included black caps seal the unused ports securely. For easy Bleeding the System was admitted to the back at the top of a vent. This simply open during filling easy and when you notice that the maximum water level is reached, simply tighten the Phillips screw and already his system is tightly and bled!

It comes with the decoupling be placed between the mounting frame and a fan. If we now draw on its mounting screws, form a radiator and fan unit combined with the airflow to the fins and take the concentrated cooling of the radiator to be cooled unfolds in the water.

Version 1.2:
New, in the all-black version of the Phobyaradiators, the cap screws brass plated black. Version 1.2 means that the pages have been fixed through a complicated procedure in the frame. This is of course a little more expensive, but it looks from first-class!

Technical data:
Materials: Copper fins, pre-chambers of brass
Color: Matt black complete
Dimensions: (L x W x H): 532x125x60mm
Connections: G1 / 4 "
Weight: about 2100g
Assembly: from both sides for fan or as a holder
Screw Thread Size: M3
Fan Size: 4 x 120mm
Pressure tested: 2 Bar

Extent of delivery:
1x Radiator
16x M3x30mm Screws
2x Black screw-in Seal plugs

Attention:
The reddish brown "stains" on the fins is no rust. Please note that this is a copper radiator and the note: "The whole radiator was coated with a robust black lacquer. The fins are coated with a thinner layer to improve the appearance without compromising cooling performance.". The lacquer coat is made from the same material, hence the reddish-brown "stains".

Attention: The radiator can be damaged, if the screws are screwed too deep. Please pay attention to the right length of the screws. The screws do not have the same size in every delivery.

Note: To avoid storage or manufacture-related residues in the circulation, Please rinse the radiator completely before assembling.